Body

Fender

~3min read
01020304050107N·mlb·ft
Tightening torque found on this page

Overview - Fender

Overview - Fender

1 - Bolt

  • 10 N·m
  • Quantity: 2

2 - Lower Bracket

  • For the fender
  • Removing and installing. Refer to → Chapter "Lower Fender Bracket, Removing and Installing".

3 - Bolt

  • 10 N·m
  • Quantity: 2

4 - Seal

5 - Bolt

  • 10 N·m
  • Quantity: 4

6 - Bolt

  • 10 N·m

7 - Fender

  • There are different versions. Refer to the Parts Catalog.
  • Removing and installing. Refer to → Chapter "Fender, Removing and Installing".

8 - Bolt

  • 10 N·m
  • Quantity: 2

9 - Bolt

  • 10 N·m
  • Quantity: 2

10 - End Plate

  • There are different versions. Refer to the Parts Catalog.
  • Removing and installing. Refer to → Chapter "End Panel, Removing and Installing".

11 - Expanding Rivet

  • Quantity: 2

Fender, Removing and Installing

Fender, Removing and Installing

Removing

- Remove the end plate. Refer to → Chapter "End Panel, Removing and Installing".

- Remove the front bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing".

- Remove the front bumper cover mount. Refer to → Chapter "Front Bumper Cover Mount, Removing and Installing".

- Remove the bolts -1, 2, and 3-.

A50-10492

- Remove the bolts -2 to 5-.

- Remove the fender -1-.

A50-10493

Installing

Install in reverse order of removal. Note the following:

- Install the seal -2- between the fender flange and the fender -1- as illustrated.

A50-10512

End Panel, Removing and Installing

Removing

- Remove the front wheel housing liner. Refer to → Chapter "Front Wheel Housing Liner, Removing and Installing".

- Left: Remove the windshield washer fluid reservoir. Refer to → Electrical Equipment; Rep. Gr.92; Windshield Washer System; Windshield Washer Fluid Reservoir, Removing and Installing.

- Right: if equipped, release the retainer -3-.

- Remove the bracket -1- in the direction of -arrow A-, and disengage downward -arrow B- and remove.

- Disconnect the connector -2- on the subframe mount control module.

A10-11669

- Remove the expanding rivets -4-.

- Remove the guide -3- on the top of the fender end plate from the fender -2-.

- Remove the end plate -1- forward starting at the bottom.

A50-10491

Installing

Install in reverse order of removal. Note the following:

- The guide -1- on the top of the end plate -2- must be pushed onto the fender -3-.

A50-10511

Lower Fender Bracket, Removing and Installing

Removing

- Remove the fender. Refer to → Chapter "Fender, Removing and Installing".

- Remove the headlamp housing. Refer to → Electrical Equipment; Rep. Gr.94; Headlamp; Headlamp, Removing and Installing.

- On the left side: free up the wiring harness and the windshield washer fluid hose for the headlamp washer system -arrows-.

- Right side: free up the wiring harness.

- Remove the bolts -2 and 3-.

- Remove the lower bracket -1-.

Installing

Install in reverse order of removal.

A50-10494