Transmission

Gears, Shafts

~2min read

Input Shaft

Input Shaft Ball Bearing, Replacing

Special tools and workshop equipment required

  • Press Plate -VW401-
  • Press Plate -VW402-
  • Press Piece - Multiple Use -VW412-
  • Press Piece - 60mm - VW415A-
  • Puller -3046-

Removing

- Remove the dual clutch -1-. Refer to → Chapter "DSG Clutch, Removing".

A30-10093

- Remove the locking ring -arrow- from the removed clutch cover.

A30-10201

- Remove the dual clutch ball bearing.

A30-10202

Note

  • There may still be a thrust washer -2- behind the ball bearing -3- depending on the clutch cover date of manufacture. If there is, then replace the old one with a new one when installing the new ball bearing.
  • Replace the ball bearing -3-.
A30-10237

Installing

Install in reverse order of removal. Note the following:

- Replace the O-ring and locking rings. Refer to → Chapter "Overview - Flywheel and Dual Clutch".

Note

The clutch cover may have or may not have a thrust washer -2-, depending on the date of manufacture. Allocation. Refer to the Parts Catalog.

- If it was there during the removal, then insert a thrust washer -2- into the cover -1-.

A30-10237

- Install the new dual clutch ball bearing all the way.

  • Position the Press Piece - 60mm -VW415A- with the thin shoulder facing up.
A30-10203

- Install the new ball bearing circlip -arrow-.

- Clean the sealing surface on the clutch cover.

A30-10201

Input Shaft Seal, Replacing

Special tools and workshop equipment required

  • Pulling Hook -T20143/2-
  • Seal Installer - Input Shaft -T40198-
  • Grease. Refer to the Parts Catalog.

Procedure

  • Secure the transmission on the Engine And Transmission Holder -VAS6095-. Refer to → Chapter "Securing on Engine and Transmission Holder".

- Remove the flywheel. Refer to → Chapter "Flywheel, Removing and Installing".

- Pry out the input shaft seal with the Pulling Hook -T20143/2-.

A39-10190

- Place the Seal Installer - Input Shaft Guide Sleeve -T40198/1- on the drive axle.

- Lightly coat the outer circumference of the new shaft seal with oil.

- Fill the space between the sealing- and dust lip half way with sealing grease. Refer to the Parts Catalog.

- Install the shaft seal on the guide sleeve.

  • Installed position: Open side of shaft seal faces transmission.
A39-10191

- Drive in the shaft seal with the Seal Installer - Input Shaft -T40198- until it stop without tilting.

- Install the flywheel. Refer to → Chapter "Flywheel, Removing and Installing".

A39-10192

Special Tools

Special Tools

Special tools and workshop equipment required

  • Press Plate -VW401-
  • Press Plate -VW402-
  • Press Piece - Multiple Use -VW412-
  • Press Piece - 60mm -VW415A-
  • Puller -3046-
  • Pulling hook -T20143/2-
W00-2958
  • Seal Installer - Input Shaft -T40198-
W00-10747