Electrical System

Horn

~2min read
01020304050118N·mlb·ft
Tightening torque found on this page

Overview - Horn

Overview - Horn

1 - Screw

  • Tightening specification: Refer to → Body Exterior; Rep. Gr.63; Front Bumper; Overview - Impact Member

2 - High Tone Horn -H2-

  • For vehicles with a TDI engine
  • Removing and installing. Refer to → Chapter "High Tone Horn -H2-/Low Tone Horn -H7-, Removing and Installing".

3 - Low Tone Horn -H7-

  • For vehicles with a TDI engine
  • Removing and installing. Refer to → Chapter "High Tone Horn -H2-/Low Tone Horn -H7-, Removing and Installing".

4 - Nut

  • 11 N·m

5 - Bracket

  • For signal horns
  • Removing and installing. Refer to → Chapter "Mount for Horns, Removing and Installing".

6 - Nut

  • 11 N·m

7 - Screw

  • 8 N·m

8 - Right Impact Member Mount

9 - Nut

  • 11 N·m

10 - Bracket

  • For the right horn
  • Removing and installing. Refer to → Chapter "Mount for Horns, Removing and Installing".

11 - High Tone Horn -H2-

  • For vehicles with a gasoline engine
  • Removing and installing. Refer to → Chapter "High Tone Horn -H2-/Low Tone Horn -H7-, Removing and Installing ".

12 - Screw

  • 8 N·m

13 - Left Impact Member Mount

14 - Nut

  • 11 N·m

15 - Bracket

  • For the left horn
  • Removing and installing. Refer to → Chapter "Mount for Horns, Removing and Installing".

16 - Low Tone Horn -H7-

  • For vehicles with a gasoline engine
  • Removing and installing. Refer to → Chapter "High Tone Horn -H2-/Low Tone Horn -H7-, Removing and Installing ".

Special Tools

Special tools and workshop equipment required

  • Fiber-Optic Repair Set - Connector Protective Caps -VAS6223/9- from Fiber-Optic Repair Set -VAS6223B-
  • Head-Up Display Calibration Board - Audi A6 -VAS6657-
  • Calibration Board - Head-Up Display -VAS6658-
W00-11495