Body

Neutral Position for Slotted Guide Rail, Checking and Adjusting

~1min read

Sedan Neutral Position

Checking

Zero position can only be checked when sunroof panel is installed.

- Boot removed.

- Drive back sunroof panel and close again.

- On vehicles with glass panel, slide sliding headliner completely toward rear.

- Close sunroof.

- For a correct zero position, guide pins -1- in center on tilting mechanism must align with marking -arrow- on link guide -2-.

Adjusting

- Sunroof motor removed.

- Remove the sunroof panel from the sunroof.

- Push the slotted guide rail on both sides by hand into the zero position.

- Adjust and install the motor in the zero position.

A60-10202

Avant Neutral Position

- Remove the sunroof panel and the Power Sunroof Control Module -J245-.

- For a correct adjustment, the tab -1- must be with the guide piece -arrows- the slotted rail -2- between both markings as shown in the illustration cut-out.

- Push the slotted guide rail on both sides by hand into the zero position.

A60-10559

Power Sunroof Control Module -J245-, Removing and Installing

Caution

After the removal and installation of the sunroof motor, the neutral position of the slotted guide rail must be checked and adjusted if necessary. Refer to → Chapter "Avant Neutral Position".

- Remove the interior lighting cover. Refer to → Electrical Equipment; Rep. Gr.96; Controls; Front Interior Lamp/Reading Lamp, Removing and Installing

- Disconnect the connectors.

- Remove the three screws. Refer to -item 1- and remove the motor through the opening in the headliner.

- After installing, perform an adaptation.