Front Seat Track Synchronization

The fore/aft manual adjuster is composed of an inboard track assembly (5), and outboard track (4) assembly, and an adjuster handle (1).

Each track assembly is made of an upper track (2) and a lower track (3). Both tracks need to be aligned prior to installing in the vehicle.

To align the front seat tracks, do the following:

1. 1
   Remove the seat from the vehicle.

   

2. 2
   Put the seat (1) upside down on a table, or on the floor as shown.
3. 3
   Unlock both tracks by pushing the adjuster handle down.
4. 4
   While pushing the adjuster handle down, move each lower track rearward until contact between the end travel stops.
5. 5
   Release the adjuster handle.
6. 6
   Move each lower track forward until an audible noise is heard, indicating that the track is fully locked.
7. 7
   At this stage both manual tracks are aligned.

   

8. 8
   Measure the overhang from the front edge of the plastic end cap (1) on the lower track to the front edge of the upper track (2).

11. Visually inspect the tracks, adjust the upper tracks flush with the front of the lower tracks. Check that the configuration in locked position is identical for both inboard (1) and outboard tracks (2).

Driver or Passenger Seat Head Restraint Replacement

Front Seat Head Restraint

Procedure

1. 1
   Raise the headrest to the full upward position.
2. 2
   Depress the flush button on the head restraint guide.
3. 3
   Remove the head restraint by pulling up on the restraint.

Front Seat Head Restraint Guide Replacement

Preliminary Procedure

Remove front seat head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement.

1. Front Seat Head Restraint Guide

Procedure

Use a flat-bladed tool to release guide for removal.

Front Seat Cushion Outer Trim Panel Replacement

Preliminary Procedure

1. 1
   Driver or passenger seat replacement. Refer to Driver or Passenger Seat Replacement
2. 2
   Remove front seat adjuster handle, if equipped. Refer to Front Seat Adjuster Replacement
3. 3
   Remove the front seat recliner handle. Refer to Driver or Passenger Seat Recliner Handle Replacement

Seat Cushion Outer Trim Panel Screw (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2,5 N·m

Seat Cushion Outer Trim Panel

Front Seat Cushion Inner Trim Panel Replacement

Preliminary Procedure

Driver or passenger seat replacement. Refer to Driver or Passenger Seat Replacement.

1. Seat Cushion Inner Trim Panel Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2,5 N·m

2. Seat Cushion Inner Trim Panel