Seat Belt Latch Stop Installation

Preliminary Procedure

1. 1
   Locate the hole in the seat belt webbing where the original seat belt stop button was located.
2. 2
   If the original hole in the seat belt webbing is not visible, perform the following:

• If either the right or left stop button is missing use the opposing seat belt as a reference.
• With the opposing seat belt fully stowed, measure the distance between the seat belt lower anchor and the stop button.
• Using the measurement obtained above, measure and mark the location of the missing stop button on the center of the seat belt webbing.

3. Ensure the seat belt latch plate is located above the mark or original hole.

Seat Belt Stop Button

Procedure

1. 1
   Work the male half of the stop button through the hole in the webbing or at the marked location.
2. 2
   Align the female half of the stop button with the male half of the stop button.
3. 3
   Snap the two halves together.
4. 4
   Trim off any access of the male half of the stop button flush with the female half of the stop button.

Tip

Ensure the male half of the stop button is facing forward in the vehicle in order to ensure the stop button will not snag customers clothing.

Driver or Passenger Seat Belt Buckle Replacement

Preliminary Procedure

Remove the front seat. Refer to Driver or Passenger Seat Replacement.

Front Seat Belt Buckle Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten 45 N·m

Front Seat Belt Buckle Assembly

Rear Seat Buckle Side Belt Replacement

Preliminary Procedure

Remove the Rear Seat Cushion. Refer to Rear Seat Cushion Replacement.

1. Rear Seat Rear Bracket Nut

Caution: Refer to Fastener Caution in the Preface section.

Tighten 45 N·m

2. Rear Seat Belt Buckle Assembly

Rear Seat Center Shoulder Belt Replacement

Preliminary Procedure

Remove the right rear seat back cushion cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement - Right Side.

1. Rear Seat Center Shoulder Belt Nut

Caution: Refer to Fastener Caution in the Preface section.

Tighten 45 N·m

2. Rear Seat Center Shoulder Belt Assembly

Shoulder Belt Replacement - Rear

Preliminary Procedure

1. 1
   Remove the body side trim panel. Refer to Body Side Trim Panel Replacement - Left Side.
2. 2
   Remove the rear window panel trim. Refer to Rear Window Panel Trim Replacement.
3. 3
   Rear Seat Shoulder Belt Anchor Plate Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten 45 N·m

2. Rear Seat Shoulder Belt Retractor Bolt

Tighten 45 N·m

3. Rear Seat Shoulder Belt Assembly

Driver or Passenger Seat Shoulder Belt Guide Adjuster Replacement

Preliminary Procedure

Remover center pillar upper garnish molding. Refer to Center Pillar Upper Garnish Molding Replacement.

1. Front Seat Shoulder Belt Guide Adjuster Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 45 N·m

2. Front Seat Shoulder Belt Guide Adjuster Assembly