Steering Linkage Outer Tie Rod Replacement

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

1. Steering Linkage Tie Rod Nut

Caution: Refer to Fastener Caution in the Preface section.

Tighten 35 N·m

2. Steering Linkage Inner Tie Rod Nut

Tighten 60 N·m

3. Steering Linkage Outer Tie Rod

Procedure

1. 1
   Use CH-161-B puller to separate the steering linkage outer tie rod from the steering knuckle.
2. 2
   Inspect the steering linkage inner tie rod for bent or damaged threads.
3. 3
   Clean the tapered surface of the steering knuckle.
4. 4
   Center the steering angle sensor. Refer to Steering Angle Sensor Centering
5. 5
   Check and adjust wheel alignment. Refer to Wheel Alignment Measurement.

Special Tools

CH-161-B Puller

For equivalent regional tools, refer to Special Tools.