Windows

Electric windows

The driver uses the controls located on the door to operate the vehicle’s electric windows.

Sequential electric window controls

There are two operating modes:

manual mode Press or pull the control switch, without going beyond the point of resistance. The window stops on release of the control switch.

automatic mode Press or pull the control switch beyond the point of resistance. The window opens or closes completely on release of the control switch.

Pressing or pulling the switch again stops the movement of the window.

Anti-pinch device

An anti-pinch device stops the window from rising. If it meets an obstacle, it goes back down.

After a battery disconnection or in the event of a malfunction, you have to re-initialise the anti-pinch function:

- Lower the window fully using the control, then close. It will rise only a few centimetres.
- Press repeatedly on the control until the window is fully closed.

Electric child safety

This allows from the front, deactivation of the opening of the rear doors and the use of the rear windows.

It is activated by means of a press on control A located on the electric windows control panel. The warning lamp in the instrument panel lights up for approx. 10 seconds.

Each time the ignition is switched on, the warning lamp comes on for approx. 10 seconds.

Opening of the doors from the outside and operation of the rear electric windows remain possible from the front of the vehicle.