Trunk fittings

1. 1
   Battery location for vehicles fitted with the V6 HDi engine.
2. 2
   Luggage compartment floor (spare wheel storage).
3. 3
   Luggage compartment light.
4. 4
   6-disc CD changer location.

• Use the 4 tie-down anchor points on the luggage compartment floor to secure your loads.

For safety reasons, in the event of heavy braking, it is recommended to place heavy objects on the floor as far forward as possible.

1. Hook

It is used to hang shopping bags.

2. Portable lamp

To recharge it, return it to its housing.

3. Storage net or closed box (V6 3 HDi engine)

It provides access to the battery.

1. Parcel shelf

(see details on the following page)

2. Tie-down anchor points

Use the 4 tie-down anchor points on the luggage compartment floor to secure your loads.

For safety reasons, in the event of heavy braking, it is recommended to place heavy objects on the floor as far forward as possible.

3. Hooks

They are used to install a high load retaining net (see details on the following page).

1. 1
   Luggage compartment light
2. 2
   12 V accessory socket (100 W max.)

This is a 12-volt socket. It is installed on the right-hand rear trim panel.

It is used to position the vehicle at the desired height to assist with loading or unloading.

It is used to hang shopping bags.

This is the location of the 6-CD changer.

• Lightly press the handle (PRESS). The load cover retracts automatically.

The movable section A can be folded down along the back of the rear seat.

• Squeeze control 1 and lift the load cover to the right, then to the left, to remove it.

• Position the left end of the load cover reel in its housing B behind the rear seat.
• Squeeze control 1 on the reel and fit it into its housing on the right C.
• Release the control to lock the load cover in place.
• Unroll it until it locks onto the luggage compartment upright.

Hooked onto the specific upper and lower anchorages, it allows you to use the full loading volume up to the roof:

• behind the rear seats (row 2),
• behind the front seats (row 1) when the rear seats are folded down.

When positioning the net, make sure the strap loops are visible from the luggage compartment; this will make them easier to handle when loosening or tightening the straps.

• fold down the rear seat backs,
• position the upper cargo restraint net reel above the two rails 1 located behind the rear seats (2/3 bench). The two notches 2 must be placed above the two rails,
• slide the two rails 1 into the notches 2 and push the reel (lengthwise) from right to left to lock it,
• refit the rear seat backs.

To use it in row 1:

• fold down the rear seat backs,
• open the covers 3 of the corresponding upper anchorages,
• unroll the upper cargo restraint net and position one end of the net's metal bar in the corresponding anchorage cover. Make sure the hook is properly seated in the rail located inside cover 3,
• pull on the metal bar of the upper cargo restraint net to position the other hook in the second anchorage cover.

To use it in row 2:

• open the covers 4 of the corresponding upper anchorages,
• from the rear bench seat, unroll the high-load retaining net, pushing it to release it from the retaining hooks,
• position one end of the net's metal bar in the corresponding anchorage cover.

  Make sure the hook is properly seated in the rail located inside the cover,

• position the other hook in the second anchorage cover and pull the metal bar towards you.