Transmission

P0760 — Shift Solenoid C Circuit Malfunction

Severity: medium Drive with care, to a shop

What P0760 means

The transmission control module detected a problem in the shift solenoid C circuit. Shift solenoids open and close fluid passages in the valve body so the transmission can select the correct gear. When the electrical signal or the solenoid's response is not what the module expects, it sets this code and may put the transmission into limp mode.

Symptoms

  • Check Engine light, sometimes with a transmission warning light
  • Harsh or delayed shifts
  • Stuck in one gear or fails to shift
  • Limp mode
  • Slipping during acceleration
  • Reduced fuel economy

Possible causes

  1. Failed shift solenoid C
  2. Damaged wiring or corroded transmission connector (open, short to ground or power)
  3. Low, dirty or degraded transmission fluid
  4. Worn or clogged valve body
  5. Faulty transmission control module (TCM/PCM) or communication problem
  6. Internal mechanical damage in the transmission

How to diagnose

  1. Scan all codes and freeze-frame data and note any other transmission codes
  2. Check ATF level and condition: color, smell, debris
  3. Inspect the transmission harness and connector for chafing, fluid intrusion and corrosion
  4. Measure solenoid C resistance and compare it to the manufacturer's spec
  5. Test power and ground to the solenoid and check the wiring to the module for opens and shorts
  6. Command the solenoid with a scan tool and watch its response
  7. Check line pressure and, if needed, drop the pan to inspect debris and the valve body
  8. If the circuit is good, evaluate the TCM and check for software updates

Common fixes

  • Replace shift solenoid C
  • Repair the wiring or connector
  • Change the ATF and filter using the correct fluid
  • Reflash or replace the TCM
  • Clean or replace the valve body, or repair the transmission internally

P0760 on different brands

Ford · manuals
On some 2024-2025 Ford gasoline applications the extended format P0760:11 indicates a circuit short to ground; it describes the monitor condition detected, not a confirmed failed part.

Questions and answers

Can I drive with code P0760?

Only a short distance and with care, such as to a repair shop. The transmission may go into limp mode or stop shifting, and continued driving raises the risk of serious damage.

What most often causes P0760?

Most often it is the solenoid itself, damaged wiring or a bad connector, or low or dirty fluid. Start by checking the fluid and the electrical circuit.

Can I just clear P0760?

You can clear it, but it will return if the cause is still there. Find the cause first, or you risk damaging the transmission.

This is general information about the code. The meaning can differ between makes and models: a scan tool and the repair manual for your car will show the exact cause.