Removal and Installation - Front Seat

Removal

1. 1
   Move the front seat to the full up and forward or rearward position to access all seat bolts.

   

2. 2
   .
   De-power the SRS
   Refer to: Disabling the Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, General Procedures).
3. 3
   
   Disconnect the front seat wiring harness electrical connector.
   

   1. Disconnect the wiring harness retainer.

   2. Disconnect the electrical connector.

   

4. 4
   Remove the front seat bolt covers.

   

5. 5
   
   Remove the front seat.
   

   • Remove and discard the seat bolts.

   

Installation

1. 1
   To install, reverse the removal procedure.
2. 2
   Install the front seat bolts in the following sequence.
   

   1. Install the front inboard bolt.
      Torque: 30 lb-ft (40 N·m)

   2. Install the front outboard bolt.
      Torque: 30 lb-ft (40 N·m)

   3. Install the rear inboard bolt.
      Torque: 30 lb-ft (40 N·m)

   4. Install the rear outboard bolt.
      Torque: 30 lb-ft (40 N·m)

   

3. 3
   Reset the SRS.
   Refer to: Supplemental Restraint System (SRS) Reset (501-20B Supplemental Restraint System, General Procedures).