General Procedures — Module Programming

Check

1. 1
   Start a programming session with the KOEO.
2. 2
   Make sure the vehicle battery is fully charged or connected to a battery charger. Battery voltage must be 12.6 - 13.6 volts while programming the vehicle.
3. 3
   Inspect the VCM II or VCMM and cables for damage. Make sure the cables remain connected throughout the programming procedure.
4. 4
   Turn off all unnecessary accessories, such as the radio, air conditioning, heated/cooled seats, headlamps, interior and courtesy lamps.
5. 5
   Disconnect any aftermarket accessories, such as remote start, security alarm, and power inverter.
6. 6
   For plug-in hybrids and electric vehicles, disconnect the external charging cord from the charge port.
7. 7
   Disable Microsoft Windows sleep mode, screen saver, and hibernation modes.

Programming

1. 1
   Log in to FDRS.
2. 2
   Click "Read VIN from Vehicle" or enter the VIN manually.
3. 3
   Select the Dashboard tab.
4. 4
   From the list on the left side of the screen, select the module for which the programming procedure is to be performed.
5. 5
   From the list on the right side of the screen, select PMI or Module Configuration.
6. 6
   Click START. Carefully follow all on-screen instructions.

Recovery

1. 1
   Disconnect the VCM II or VCMM from the DLC and PC.
2. 2
   Start FDRS and log in.
3. 3
   In the Device Manager window that appears, select CANCEL.
4. 4
   Select the appropriate VIN in the vehicle identification menu or use manual VIN entry and select GO.
5. 5
   In the Automotive Communication Device Not Detected window that populates, select CONTINUE. If the Device Explorer window appears, select CANCEL.
6. 6
   After the session has started, reconnect the VCM II/VCMM to the DLC and PC. The VCM II/VCMM icon should turn green in the lower right corner of the screen. If it does not, troubleshoot the FDRS connection to the VCM II or VCMM.
7. 7
   In the Toolbox menu, navigate to the faulty module and select Download/Run PMI. Follow the on-screen instructions. When asked whether the original module is installed, select NO and continue the installation of the application.
8. 8
   After programming is complete, a list of additional steps required to complete the programming process may appear on the screen. Make sure all applicable steps are performed in order.