General Procedures - Transport Mode Deactivation

Deactivation

If the IPC displays FACTORY MODE CONTACT DEALER in the message center, the vehicle is set to factory mode. The system will not automatically return to another mode and must be manually set to either transport or normal operating mode. Refer to the Factory Mode Deactivation procedure in this section.

1. 1
   Set the ignition to the OFF position.
2. 2
   Make sure the battery is fully charged.
   Refer to: Battery Charging (414-01 Battery, Mounting and Cables, General Procedures).
3. 3
   Turn the ignition to the ON position.
4. 4
   Press and release the brake pedal 5 times.
5. 5
   Press and release the hazard switch button 2 times.
6. 6
   Start the engine.
7. 7
   Set the ignition to the OFF position.
8. 8
   Make sure the RKE operates correctly.