Brake Fluid Reservoir - Removal and Installation

Materials

Removal

NOTICE: If fluid spills on the painted surface, the affected area must be washed immediately with cold water.

1. 1
   Disconnect the electrical connector, remove the screws and the headlamp assembly.

   

2. 2
   Remove the bolt and rotate the cowl vent panel upward.
   Torque: 62 lb-in (7 N·m)

   

3. 3
   Using a suitable suction device, remove the brake fluid from the remote reservoir, then remove the nuts.
   Material: Motorcraft® DOT 4 LV High Performance Automotive Brake Fluid / PM-20 (WSS-M6C65-A2)
   Torque: 62 lb-in (7 N·m)

   

4. 4
   Disconnect the clip and remove the brake fluid remote reservoir.

   

Installation

1. To install, reverse the removal procedure.