Ford Focus Quiz
Powertrain

Halfshaft Seal - RH (Manual Transaxle/Transmission — MTX75)

In this manual: Powertrain
Vehicle - General — 4Accessories — 40Body — 237Chassis — 113Electrical — 19HVAC — 44Powertrain — 292
5steps
~45min
4/5difficulty
3special tools
0204060801003526N·mlb·ft
Tightening torque found on this page
Done 0 of 5
Special Tool(s)
Installer, Halfshaft Oil Seal 308-039
Remover, Halfshaft Oil Seal 307-163 (T86P-70043-A)
Remover, Pilot Bearing 308-001 (T58L-101-B)

Material
Item Specification
Motorcraft® Full Synthetic Manual Transmission Fluid XT-M5-QS WSD-M2C200-C
Removal
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
  2. Remove the RH halfshaft and intermediate shaft assembly. For additional information, refer to Section 205-04.
  3. Using the Pilot Bearing Remover with the Halfshaft Oil Seal Remover, remove and discard the halfshaft oil seal.
Installation
  1. Using the Halfshaft Oil Seal Installer, install the new halfshaft oil seal.
  1. Install the RH halfshaft and intermediate shaft assembly. For additional information, refer to Section 205-04.
  2. NOTE: The fill height is 0.0-5.0 mm (0.0-0.2 in) below the lower edge of the filler hole.

    Remove the transaxle fluid filler plug. Check the transaxle fluid level and fill with manual transmission fluid as necessary.

    • Tighten to 35 N·m.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.