Ford Focus Quiz
Powertrain

Ignition Coil-On-Plug

In this manual: Powertrain
Vehicle - General — 4Accessories — 40Body — 237Chassis — 113Electrical — 19HVAC — 44Powertrain — 292
3steps
~18min
2/5difficulty
01020304050107N·mlb·ft
Tightening torque found on this page
Done 0 of 3
Material
Item Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound
XG-3-A		 ESE-M1C171-A
Removal and Installation
  1. Disconnect the ignition coil-on-plug electrical connector.
  2. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

    Remove the bolt and the ignition coil.

    • To install, tighten to 10 N·m.
  3. Inspect the coil boots for rips, nicks or tears. Remove and discard any damaged coil boots.
    • To install, slide the new coil boot onto the coil until it is fully seated at the top of the coil.
  1. To install, reverse the removal procedure.
    • Apply silicone dielectric compound to the inside of the ignition coil boot.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.