Ford Focus Quiz
Chassis

Power Steering Pump Pulley

In this manual: Chassis
Vehicle - General — 4Accessories — 40Body — 237Chassis — 113Electrical — 19HVAC — 44Powertrain — 292
8steps
~58min
4/5difficulty
2special tools
0102030405043N·mlb·ft
Tightening torque found on this page
Done 0 of 8
Special Tool(s)
Installer, Power Steering Pump Pulley 211-185 (T91P-3A733-A)
Remover, Power Steering Pump Pulley 211-016 (T69L-10300-B)
Removal
Item Part Number Description
1 6C301 Accessory drive belt
2 3A733 Power steering pump pulley
3 6775 Accessory drive belt splash shield
4 — Accessory drive belt splash shield bolts (2 required)




Item Part Number Description
5 W701107 Coolant expansion tank bolts (2 required)
6 8C045 Coolant expansion tank

NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material, or failure of the power steering components may result.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
  2. Remove the 2 bolts and the accessory drive belt splash shield.
  3. Rotate the accessory drive belt tensioner clockwise and position the accessory drive belt away from the power steering pump pulley.
  4. Remove the 2 engine coolant expansion tank bolts, carefully pull the reservoir up and off the locating pin and position it aside.
  5. Using the Power Steering Pump Pulley Remover, remove the power steering pump pulley.
Installation
  1. NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.

    Using the Power Steering Pump Pulley Installer, install the power steering pump pulley.

  1. Position the engine coolant reservoir onto the locating pin and install the 2 bolts.
    • Tighten to 4 N·m.
  2. Rotate the tensioner clockwise and position the accessory drive belt on the power steering pump pulley.
  3. Position the accessory drive belt splash shield and install the 2 bolts.
    • Tighten to 9 N·m.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.