Roof Opening Panel - Removal and Installation

NOTE: Make sure the roof opening panel is in the CLOSED position.

Remove the headliner. For additional information, refer to Section 501-05.

Disconnect the 2 front and the 2 rear drain hoses from the roof opening panel.

Disconnect the roof opening panel motor electrical connector.

Remove the 12 bolts and the roof opening panel.

• With the aid of an assistant, compress the legs of the roof opening panel retaining clip and lower the roof opening panel.

If installing a new roof opening panel frame, transfer components as necessary.

NOTE: The roof opening panel must be correctly located on the retaining clip before tightening the roof opening panel bolts. NOTE:

Do not fully tighten the roof opening panel frame bolts at this stage.

Compress the legs of the roof opening panel retaining clip and install the roof opening panel.

• Loosely install the 12 bolts.

Tighten the 12 roof opening panel frame bolts in the sequence shown.

• Tighten to 9 N·m.

Connect the roof opening panel motor electrical connector.

Connect the 2 front and the 2 rear drain hoses to the roof opening panel.

Install the headliner. For additional information, refer to Section 501-05.

Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization in this section.