Safety Belt Retractor - Rear, Outboard

NOTE:

LH shown, RH similar.

Item	Part Number	Description
1	—	Outboard safety belt anchor bolt (part of 611B68)
2	611B68	Outboard safety belt retractor
3	—	Outboard safety belt retractor bolt (part of 611B68)

Removal and Installation WARNING: After
any crash, all of the following safety belt assemblies and attaching hardware must be inspected to verify correct function:

• Retractors
• Buckles
• Belt tension sensor (BTS) (if equipped)
• Front safety belt buckle support assemblies (slide bar) (if equipped)
• Safety belt shoulder belt height adjusters (if equipped)
• Child safety seat tether bracket assemblies
• Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)

If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion of this section, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash. After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.

1. 1
   Remove the quarter trim panel. For additional information, refer to Section 501-05.
2. 2
   Remove the safety belt retractor anchor bolt.

   • To install, tighten to 40 N·m.
3. 3
   Remove the bolt and safety belt retractor.

   • To install, tighten to 40 N·m.
4. 4
   NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

   To install, reverse the removal procedure.

5. 5
   Check the active restraint system for correct operation. For additional information, refer to Safety Belt System in this section.