Chassis

Strut and Spring Assembly - Removal and Installation

9steps
~54min
2/5difficulty
0204060801006346N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Item Part Number Description
1 W715135 Stabilizer bar link upper nut
2 18K001 LH/ 18045 RH Strut and spring assembly
3 W520102 Strut upper nut (3 required)
4 — Brake hose
5 W711725 Wheel knuckle-to-strut bolt

Removal and Installation NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct retention of these parts.
  1. Remove the wheel and tire. For additional information, refer to Section 204-04.
  2. Detach the brake hose from the support bracket.
  1. Remove the stabilizer bar link upper nut and detach the link from the strut.
    • Discard the nut.
    • To install, tighten the new nut to 63 N·m.
  2. Remove and discard the wheel knuckle-to-strut bolt.
    • To install, tighten the new bolt to 150 N·m.
  3. Detach the wheel knuckle from the strut and spring assembly.
    • Support the halfshaft using mechanic's wire.
  4. NOTICE: Support the strut and spring assembly to prevent damage.

    Remove and discard the strut upper nuts.

    • To install, tighten the new nuts to 35 N·m.
  5. Remove the strut and spring assembly.
  6. To install, reverse the removal procedure.
    • For additional information on the disassembly and assembly of the strut and spring assembly, refer to Strut and Spring Assembly in this section.
  7. Check and, if necessary, align the front end. For additional information, refer to Section 204-00.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.