Ford Focus Quiz
Body

Subframe - Rear

In this manual: Body
Vehicle - General — 4Accessories — 40Body — 237Chassis — 113Electrical — 19HVAC — 44Powertrain — 292
13steps
~78min
3/5difficulty
0408012016020011585N·mlb·ft
Tightening torque found on this page
Done 0 of 13

Item Part Number Description
1 W709634-S439 Crossmember bolts (6 required)
2 5K067 Crossmember
3 W500744 Front lower arm inboard bolts (2 required)
4 W500744 Upper arm inboard bolts (2 required)
5 5500 Lower arm
6 W500744 Lower arm outboard bolts (2 required)
7 W703217 Lower arm outboard nuts (2 required)
8 W703217 Upper arm inboard nuts (2 required)

Removal NOTICE: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
  1. Remove both rear springs. For additional information, refer to Section 204-02.
  2. Remove both rear lower control arms. For additional information, refer to Section 204-02.
  3. Remove the stabilizer bar. For additional information, refer to Section 204-02.
  4. Remove and discard the front lower arm inboard bolts.
    • To install, tighten to 115 N·m.
  5. Remove and discard the upper arm inboard bolts.
    • To install, tighten to 115 N·m.
  6. Support the wheel knuckle and trailing arm assembly using a tie strap or other suitable holding device.
  1. Using a suitable jackstand, support the exhaust system.
  2. Detach the exhaust system from the crossmember exhaust hanger isolator.
  1. Using a suitable jack, support the crossmember.
  2. Remove the 6 crossmember bolts.
    • To install, tighten to 103 N·m.
  3. Lower the jack and remove the crossmember.
  4. To install, reverse the removal procedure.
    • If installing a new rear subframe, transfer parts as necessary.
  5. Check and, if necessary, adjust the rear toe. For additional information, refer to Section 204-00.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.