Steering Gear. Removal and Installation

Removal

1. 1
   When installing a new steering gear, download the PSCM configuration from the scan tool.
   Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).
2. 2
   Remove the front subframe.
   Refer to: Front Subframe - 2.7 L EcoBoost (238 kW/324 L PS) (502-00 Uni-Body, Subframe and Mounting System, Removal and Installation).
3. 3
   Remove the steering gear boot.

   

4. 4
   Remove and discard the steering gear mounting bolts.
   Torque: 148 lb-ft (200 N·m)

   

5. 5
   Position the front stabilizer bar aside. Remove the steering gear.

   

Installation

1. 1

   NOTICE: Make sure the boot is correctly installed before installing the steering gear on the vehicle. If the boot is not correctly installed, it may cause heavy friction with the input shaft, which may result in internal steering gear damage.

   To install, reverse the removal procedure.
   Inspect and install the steering gear boot onto the steering gear, as illustrated.

   

2. 2
   If a new steering gear was installed, download the PSCM configuration from the scan tool to the new PSCM.
   Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).