Bushing - Stabilizer Bar

Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to ensure correct retention of these parts.

1. Raise the vehicle on a hoist.

2. Remove the wheel and tire assemblies.

3. Disconnect the front stabilizer bar links (5K483) from the front stabilizer bar (5482).

1. Remove the nuts and bushings. Discard the nuts.

2. Rotate the stabilizer bar to disconnect the links.

4. Remove and discard the nuts.

5. Remove the stabilizer bar bracket (5486) and the stabilizer bar mounting bracket adapter (5B482).

6. Cut the stabilizer bar insulators (5493) from the stabilizer bar.

Installation

1. NOTE: To aid installation, coat the necessary parts of the front stabilizer bar and the inside diameter of the stabilizer bar bushing with Rubber Suspension Insulator Lube E25Y-19553-A or equivalent meeting Ford specification ESF-M99B112-A.

To install, reverse the removal procedure.