Ford Mustang Quiz
Brake System

Cable and Conduit

In this manual: Brake System
Service Information — 34Suspension — 63Driveline — 80Brake System — 74Steering System — 42Engine — 329Automatic Transmission — 84Manual Transmission, Clutch and Transfer Case — 64Exhaust System — 8Fuel System — 39Climate Control System — 76Instrumentation and Warning Systems — 25Battery and Charging System — 19Audio Systems — 14Lighting — 24Electrical Distribution — 8Electronic Feature Group — 11Body — 173Frame and Mounting — 6General Information — 1
~1min read

Removal

NOTE: The RH rear is shown, the LH is similar.

1. CAUTION: If any component in the parking brake system requires repair or if the rear axle housing (4010) is removed, the cable tension must be released.

Release the cable tension. For additional information, refer to Parking Brake Cable Tension Release in this section.

2. Disconnect the parking brake rear cable and conduit.

Cable and Conduit

3. Using a 13 mm (0.52 in) box-end wrench, depress the conduit retaining prongs and remove the parking brake rear cable and conduit.

Cable and Conduit

4. Remove the parking brake rear cable and conduit from the routing clip bolts.

Cable and Conduit

5. Disconnect the parking brake rear cable and conduit from the parking brake lever (2A637).

Cable and Conduit

6. Remove the clip from the rear disc brake caliper (2552).

Cable and Conduit

7. Remove the parking brake rear cable and conduit from the rear disc brake caliper.

Cable and Conduit

Installation

1. Follow the removal procedure in reverse order.

Cable and Conduit

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.