Installation

1. Overlay the new rear window glass assembly over the old rear window glass assembly and transpose the markings with a grease pencil.

2. Center the V-notch on the new rear window glass assembly to the center mark on the top of the number four bow.

3. Align the rear window glass assembly to the top groove of the number four bow and staple the entire length.

4. Starting at the center of the lower rear tacking strip, align the top edge of the rear belt to the reference line and staple.

5. Repeat the procedure for both rear tacking strip sides.

6. Position and staple the water diverter.

7. If necessary, align the elastic straps with the edge of the rear window glass assembly and staple in place.

8. Align the center line mark on the cover assembly to the V-notch on the rear window glass assembly and staple the entire length.

9. Align the top edge of the quarter tacking strip to the reference line on the convertible top cover and staple.

10. Install the tacking strips over the body studs.

11. Tighten the tacking strip nuts.

12. Install the well sling.

13. If necessary, connect the rear defroster connectors.