Lumbar Motor

Removal and Installation

All vehicles

1. Remove the front seat. For additional information, refer to Seat-Front Power in this section.

2. Disconnect the power seat track electrical connector.

3. Remove the four seat track bolts.

Vehicles with standard power lumbar

4. Release the J-clip.

5. Remove the front seat backrest pad adjusting pump screws.

6. Remove the front seat backrest pad adjusting pump (65530).

1. Disconnect the electrical connector.

2. Disconnect the power lumbar support air hose.

Vehicles with power bolster and lumbar

7. Remove the driver seat backrest latch. For additional information, refer to Latch-Front Seat Backrest in this section.

8. Remove the pivot bolt and seat backrest.

• Disconnect the power lumbar support air hoses.

9. Release the J-clips.

10. NOTE: When removing the cushion from the frame, it is not necessary to remove the trim cover from the cushion foam pad.

Remove the cushion foam pad from the frame.

11. NOTE: The lumbar and bolster pump and solenoid module is serviced as part of the cushion frame assembly.

Install a new seat cushion frame assembly.

All vehicles

12. To install, reverse the removal procedure.