Powertrain
Throttle Body Carbon Accumulation Check (Except K24Z7)
Check
- HDS DLC - Connection
 |
|
1. |
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard. |
|
2. |
Turn the ignition switch to ON (II). |
|
3. |
Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting. |
|
- THROTTLE BODY CARBON ACCUMULATION - CHECK
|
NOTE: If the malfunction indicator lamp (MIL) has been reported on, check for diagnostic trouble codes (DTCs).
|
1. |
Start the engine. Hold the engine speed at 3,000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle. |
|
2. |
Check the REL TP SENSOR in the DATA LIST with the HDS. The reading should be below 2.46 deg. If it is not, clean the throttle body. |
|
?
Test yourself
A quick Honda Civic quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?