Tailgate Spoiler Replacement

Special Tools Required

• KTC Trim Tool Set SOJATP2014

*Available through the Honda Tool and Equipment Program; call 888-424-6857

For Some Models

NOTE:

• Take care not to scratch the body.

• Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. 1

   Pry up at the notches (A) with a flat-tip screwdriver wrapped with protective tape to release the hooks (B), then remove the lids (C) from both sides.

2. 2

   Remove the bolts.

3. 3

   Lift up on the tailgate spoiler (A) to detach the pins (B) of the clips from the grommets (C), then remove the spoiler.

4. 4

   Remove the grommets from the tailgate with snap ring pliers.

5. 5

   If the grommets or the pins are damaged or stress-whitened, replace them. Always replace both the pin and the grommet if either is damaged.

6. 6

   Install the grommets on the pins by pushing them into place.

7. 7

   Install the spoiler in the reverse order of removal, and push the clips into place securely.