Power Mirror Actuator Replacement

Removal

1. 1

   Remove these items:

   • Mirror holder

   • Power mirror

2. 2

   Record the power mirror connector terminals location and the wire harness colors.

3. 3

   Disassemble the power mirror connector (A), and remove the terminals (B) from the connector.

4. 4

   Remove the gasket (A) and the cover (B).

5. 5

   Remove the three screws, and separate the mirror housing (C) from the bracket (D).

6. 6

   Remove the four screws, and separate the power mirror actuator (A) from the housing (B).

Installation

1. 1

   Route the wire harness of the new actuator through the hole in the bracket and gasket, then install the parts in the reverse order of removal.

2. 2

   Insert the new actuator terminals into the connector in the original arrangement.

3. 3

   Apply tape in the areas shown (A), to seal the wire harness.

4. 4

   Reassemble in the reverse order of disassembly.

   NOTE: Be careful not to break the mirror when reinstalling it to the actuator.

5. 5

   Reinstall the mirror assembly on the door.

6. 6

   Operate the power mirror to ensure smooth operation.