Side Impact Sensor (Second) Replacement

Removal

1. 1

   Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. 2

   Remove the cargo area side trim.

3. 3

   Disconnect the side impact sensor (second) 2P connector (A) on the floor wire harness.

4. 4

   Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).

Installation

1. 1

   Install the side impact sensor (second) (A) with a new TORX bolt (B), using a TORX T30 bit. Connect the side impact sensor (second) 2P connector (C) on the floor wire harness.

2. 2

   Do the battery terminal reconnection procedure.

3. 3

   Clear any DTCs with the HDS.

4. 4

   Confirm proper SRS operation: Turn the ignition switch to ON (II) , and check that the SRS indicator comes on for about 6 seconds, and then goes off.

5. 5

   Reinstall all removed parts.