Intermediate Shaft Reassembly (A/T)

Exploded View

Special Tools Required

• Oil Seal Driver, 65 mm 07JAD-PL90100
• Bearing Driver Attachment, 52 x 55 mm 07746-0010400
• Bearing Driver Attachment, 35 mm I.D. 07746-0030400
• Driver Handle, 15 x 135L 07749-0010000

NOTE: Refer to the Exploded View, as needed, during this procedure.

1. 1

   Clean the disassembled parts with solvent, and dry them with compressed air.

   NOTE: Do not wash the rubber parts with solvent.

2. 2

   Press a new intermediate shaft bearing (A) into the bearing support (B) using the 52 x 55 mm bearing driver attachment (C), the 15 x 135L driver handle (D), and a press.

   

3. 3

   Install the internal snap ring (A) into the groove (B) of the bearing support.

   

4. 4

   Press the intermediate shaft (A) into the shaft bearing (B) using the 35 mm inner bearing driver attachment (C) and a press.

   

5. 5

   Install the external snap ring (A) in the groove of the intermediate shaft (B).

   

6. 6

   Install a new outer seal (A) into the bearing support (B) using the 65 mm oil seal driver (C) and a press. Press the seal until it is 0В±0.2 mm (0В±0.008 in) below the surface of the bearing support end.