Electrical
Alternator Reassembly
In this manual: Electrical
8steps
~48min
2/5difficulty
Done 0 of 8
If you removed the OAD pulley, install it.
Remove any grease or any oil from the slip rings.
Put the rear housing assembly and the drive-end housing/rotor assembly together, tighten the four through bolts.
Push the brushes (A) in, then insert a pin or drill bit (B) (about 1.6 mm (1/16 in) diameter) to hold them there.
Install the brush holder assembly, and pull out the pin or drill bit.
Install the end cover.
After assembling the alternator, turn the pulley by hand to make sure the rotor turns smoothly and without noise.
Install the alternator.
Was this page helpful?