Body

Audio Display Visor Removal/Installation

3steps
~18min
2/5difficulty
Done 0 of 3

NOTE:

  • Do this procedure in a clean place free from dirt.

  • Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).

  • When removing the audio display visor, do not touch the LCD facing.

  • If there is dirt on the LCD facing, clean it using compressed air.

  • When installing the audio display visor onto the LCD assembly, be careful not to touch the LCD facing.

  • Check that the audio display visor and the LCD assembly are properly installed.

  • Since the LCD assembly and the audio display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.

  • Check that the audio display unit assembly has no damage.

  • When removing the audio display visor, do not hold the LCD facing down.

  1. Remove the audio display-USB adapter control unit.

  2. Remove the screws and the LCD assembly (A) from the audio display visor (B).

  3. Install the audio display visor reverse order of removal.