Reconnect the connector to the headlight leveling control unit, and do the following input tests:
If any tests indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, replace the headlight leveling control unit.
NOTE: After replacing the control unit, do the headlight initial position learning procedure.
Cavity |
Wire |
Test condition |
Test: Desired result |
Possible cause if desired result is not obtained |
7 |
GRN |
Ignition switch ON (II), headlight switch ON |
Measure the voltage between terminals No. 7 and No. 6: There should be battery voltage. |
|
6 |
YEL |
14 |
BRN |
Ignition switch ON (II), headlight switch ON |
Measure the voltage between terminals No. 14 and No. 6: There should be about 2 to 12 V. |
|
6 |
YEL |
5 |
PUR |
Under all conditions |
|
|
3 |
LT GRN |
12 |
PNK |
5 |
PUR |
Under all conditions |
|
|
2 |
WHT |
12 |
PNK |