Maintenance
High Beam Headlight
In this manual: Maintenance
~1min read

Driver’s side
1. Remove the clips using a flat-tip screwdriver, then remove the upper part of the air intake duct.

Passenger’s side
1. Remove the clips using a flat-tip screwdriver, then remove the engine coolant reservoir out of its stay.

Remove the power steering reservoir from the stay bracket.
Holding clip
Insert a flat-tip screwdriver, lift and remove the central pin to remove the clip.

Insert the clip with the central pin raised, and push until it is flat.


2. Remove the coupler.
► It can be removed by pushing the tab.
3. Rotate the old bulb to the left to remove.
4. Insert a new bulb into the headlight assembly and turn it to the right.
5. Insert the coupler into the connector of the bulb.
Was this page helpful?