Electrical Installation In this manual: Electrical Vehicle General — 4Accessories — 103Body — 232Chassis — 83Electrical — 28HVAC — 26 5steps ~30min 2/5difficulty 03060901201508059N·mlb·ftTightening torque found on this page Done 0 of 5 Step-by-step mode Reset 1Loosely tighten the OAD pulley (A), then insert the alternator OAD pulley holder (B) into the OAD pulley.2Place a 10 mm deep socket wrench (A) through center of the alternator OAD pulley holder (B), onto the hex on the end of the alternator shaft.3Hold the alternator OAD pulley holder with a 17 mm wrench (C), then tighten the alternator shaft counterclockwise to the specified torque. Specified Torque: 80 N·m 4Install the new OAD pulley seal cap (A). NOTE: When installing do not distort the OAD pulley seal cap. Make sure to check that the cap is installed securely. 5Install the alternator. ← Previous Removal Next → Data and Communication Network Was this page helpful?👍 Yes👎 No