Body
Moonroof Glass Position Adjustment
In this manual: Body
5steps
~30min
2/5difficulty
Done 0 of 5
The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/-1 mm (0+0.04/-0.04 in) all the way around, and the weatherstrip should evenly touch the roof panel at the front and rear. If not, make the following adjustment:
Remove the bracket cover.
Adjust the glass (A).
Slightly loosen the screws with a TORX T25 bit.
Move the glass up or down.
Tighten all screws securely.
If necessary, repeat on the opposite side.
Reset the moonroof control unit.
Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use high-pressure water.
NOTE: It is normal for some water to seep past the moonroof into the moonroof frame, and exit through the drains.
Was this page helpful?