Accessories

Multi-Information Switch Test/Replacement

6steps
~36min
2/5difficulty
Done 0 of 6

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures before doing repairs or servicing.

  1. Remove the driver's airbag assembly.

  2. Remove the three screws (A), then remove the steering wheel trim (B), and disconnect connectors (C) from each switches.

  3. Remove the cover (D).

  4. Remove the switch mounting screws (E), then remove the multi-information switch (F) from the steering wheel trim.

  5. Measure the resistance between terminals No. 1 and No. 5 in each position according to the table.

    Position

    Resistance

    ^

    About 33 ?

    SEL/RESET

    About 1043 ?

    Ў

    About 363 ?

  6. If the switch is OK, but there is a problem with the switch function, check the cable reel subharness and cable reel.