Body

Power Lumbar Support Switch Test/Replacement

5steps
~30min
2/5difficulty
Done 0 of 5

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures before doing repairs or servicing.

  1. Remove the driver's recline cover.

  2. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).

  3. Check for continuity between the terminals in each switch position according to the table.

  4. If the continuity is not as specified, replace the switch.

  5. Install the switch in the reverse order of removal.