Body

Power Seat Adjustment Switch Test/Replacement

8steps
~48min
2/5difficulty
Done 0 of 8

NOTE: SRS components are located in this area. Review the SRS component locations, and precautions and procedures before doing repairs or servicing.

  1. Remove the driver's seat.

  2. Remove the power seat adjustment switch knobs (A) from the power seat adjustment switch (B).

  3. Remove the driver's seat front cover and recline cover.

  4. Disconnect the 12P connector from the switch, then remove the two screws.

  5. Reinstall the adjustment switch knobs to the switch.

  6. Check for continuity between the terminals in each position according to the table.

  7. If the continuity is not as specified, replace the switch.

  8. Install the part in the reverse order of removal.