Body Washer Motor/Reservoir Replacement In this manual: Body Vehicle General — 4Accessories — 103Body — 232Chassis — 83Electrical — 28HVAC — 26 5steps ~30min 2/5difficulty 010203040509.47N·mlb·ftTightening torque found on this page Done 0 of 5 Step-by-step mode Reset 1Remove the right front inner fender.2Disconnect the 2P connector(s) (A) from the windshield washer motor (B) and the washer fluid level switch (C) (Canada models). Washer Reservoir Capacity: 2.5 L (2.64 US qt): USA models 4.5 L (4.76 US qt): Canada models 3Disconnect the washer tube (D), then if necessary, remove the washer motor and the washer fluid level switch (Canada models). NOTE: Fluid may flow out of the opening.4Remove the clip (A) and two bolts (B) from the washer reservoir (C).5Install the washer reservoir in the reverse order of removal. Check the washer motor operation. ← Previous Wipers/Washers System Description Next → Wiper Motor Replacement Was this page helpful?👍 Yes👎 No