Chassis

Wheel Bearing End Play Inspection

6steps
~36min
2/5difficulty
0408012016020012794N·mlb·ft
Tightening torque found on this page
Done 0 of 6
  1. Raise and support the vehicle.

  2. Remove the wheels.

  3. Install suitable flat washers (A) and the wheel nuts (B). Tighten the nuts to the specified torque to hold the brake disc or the brake disc/drum securely against the hub.

  4. Attach the dial gauge. Place the dial gauge against the hub flange.

  5. Measure the bearing end play while moving the brake disc or the brake disc/drum inward and outward.

    Wheel bearing end play:

    Front/Rear: 0-0.05 mm (0-0.0020 in)

  6. If the bearing end play measurement is more than the standard, replace the hub bearing unit.