Hyundai Elantra AD Quiz
Body Electrical System

AVN Remote Control Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
9steps
~54min
2/5difficulty
Done 0 of 9

Inspection

  1. Check the resistance between terminals at each switch position (LH).
    [LH: Audio + Hands-Free]
    Switch Connector
    Terminal    		 Resistance
    (±5%)
    SEEK UP 2-5 430 ?
    SEEK DOWN 1.11 kΩ
    MODE 2.11 kΩ
    MUTE 3.11 kΩ
    VOL (+) 4.61 kΩ
    VOL (-) 6.81 kΩ
    Voice 10.71 kΩ
    SEND 18.91 kΩ
    END 40.91 kΩ
  2. Check the resistance between terminals at each switch position (RH).
    [RH: Trip + Cruise]
    Switch Connector
    Terminal    		 Resistance
    (±5%)
    Cancel 2-5 330 ?
    SET - 550 ?
    VOICE + 880 ?
    CRUISE ON/OFF 1.44 kΩ
    GROUP 3-5 550 ?
    STEP 880 ?
    TRIP DOWN 1.44 kΩ
    ENTER 2.54 kΩ
    SCC ON/OFF 5.54 kΩ

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering wheel assembly. (Refer to Steering System – Steering Wheel)
  3. Remove the steering column rear cover (A).
  4. Disconnect the remote control connector on the steering wheel (A).
  5. Remove the steering wheel remote control after loosening the screws.

Installation

  1. Install the steering wheel remote control after connecting the connector.
  2. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.