Hyundai Elantra AD Quiz
Engine Electrical System

Cruise Control Switch Repair Procedures

In this manual: Engine Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
10steps
~60min
3/5difficulty
Done 0 of 10

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the steering wheel assembly.
  3. Remove the screws from the steering wheel rear cover (A).
  4. Disconnect the remote control connector on the steering wheel (A).
  5. After loosening the screws, remove the steering remote control switch (A).

Installation

  1. After connecting the connector, install the remote control switch on the steering wheel and install the cover.
  2. Install the steering wheel and the driver airbag module.
  3. Connect the negative (-) battery terminal.

Inspection

  1. Remove the cruise control switch.
  2. Measure the resistance between the terminals of the control switch when each function switch is in the ON position (and the switch is pressed).
    Switch Connector Terminal Resistance (± 5%)
    CANCEL 2 ~ 5 330 ?
    SET - 2 ~ 5 550 ?
    VOICE + 2 ~ 5 880 ?
    CRUISE 2 ~ 5 1.44 kΩ

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.