Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Outside Rear View Mirror Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
4steps
~24min
2/5difficulty
0102030405010.88N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Replacement
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • Be careful not to scratch the body surface.
  1. Using a screwdriver or removal tool, remove the front door handle bezel inner cover (A).
  2. Disconnect the outside rear view mirror connector (A).
  3. Loosen the mounting nuts and remove the outside rear view mirror (A).

    Tightening torque: 6.9 ~ 10.8 N·m

  4. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.