Hyundai Elantra AD Quiz
Body Electrical System

Power Mirror Switch Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

[Power Window Switch]
  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver door trim panel. (Refer to Body - "Front Door Trim Panel")
  3. Disconnect the power mirror switch connector from the door trim.
  4. Check the circuit continuity between terminals at each switch position according to the table. [Power Mirror Switch]

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Remove the power window unit (A).

Installation

  1. Install the power window switch assembly.
  2. Install the front door trim panel after connecting the connector.
  3. Connect the negative (-) battery terminal.
    • Make sure the switch connectors are connected correctly.
    • Check that the power outside mirror system operates normally.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.