Hyundai Elantra AD Quiz
Body Electrical System

Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
4steps
~24min
2/5difficulty
Done 0 of 4

Removal

  1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")
  2. Remove the high-pitched and low-pitched horns after disconnecting the horn connector (A) and loosening the mounting bolt. [Low-Pitched Horn]
    [High-Pitched Horn]

Installation

  1. Install the horn after connecting the horn connectors.
  2. Install the front bumper cover.

Inspection

  1. On this vehicle, the horn relay is installed in the PCB block of the engine room relay box.
  • The solid-state relay inserted into the PCB is not serviceable separately.
  • If the relay needs to be replaced, replace the PCB block and perform the test.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.