Hyundai Kona Quiz
Body (Interior and Exterior)

Front Seat Belt Pretensioner Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Replacement

  1. Remove the center pillar upper garnish. (Refer to Body Trim - "Center Pillar Garnish")
  2. Loosen the mounting bolt and remove the front lower seat belt anchor (A).

    Torque: 39.2 – 54 N·m

  3. Loosen the upper front seat belt anchor mounting bolt and remove the upper front seat belt anchor (A).

    Torque: 39.2 – 54 N·m

  4. Disconnect the front seat belt pretensioner connector (A).
  5. Loosen the mounting bolt and remove the front seat belt pretensioner (A).

    Torque: 39.2 – 54 N·m

  6. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.