Hyundai Kona Quiz
Heating, Ventilation, and Air Conditioning

Heater and A/C Control Unit (Manual) Repair Procedures

In this manual: Heating, Ventilation, and Air Conditioning
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
10steps
~60min
3/5difficulty
Done 0 of 10

Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel. (Refer to Crash Pad - "Crash Pad Lower Panel")
  3. Remove the airbag assembly cover [RH]. (Refer to Crash Pad - "Crash Pad Trim Assembly [RH]")
  4. Remove the floor console upper front trim. (Refer to Floor Console - "Floor Console Assembly")
  5. Remove the glove box. (Refer to Body - Glove Box)
  6. Remove the shower duct (A) after loosening the screw. [LH]
    [RH]
  7. Disconnect the manual controller cable (A). [LH]
    [RH]
  8. After loosening the mounting screws, remove the heater and air conditioning controller unit (A).
  9. Disconnect the connector (A) and the air hose (B).
  10. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.