Power Door Lock Actuator Repair Procedures

Inspection

1. 1
   Remove the front door trim panel. (Refer to Body - "Front Door Trim")
2. 2
   Remove the front door module. (Refer to Body - "Front Door Module")
3. 3
   Disconnect the actuator connector.

   

   No	Terminal Information
   	left	Right Side
   1	-	-
   2	Lock/Unlock Switch	Motor 2
   3	COM	Motor 3
   4	Key Lock Switch	Key Unlock Switch
   5	Key Unlock Switch	Key Lock Switch
   6	Motor 3	COM
   7	Motor 2	Lock/Unlock Switch
   8	-	-

4. 4
   Check actuator operation by connecting power and ground according to the table. To prevent actuator damage, apply battery voltage only momentarily.

   

   

5. 5
   Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
6. 6
   Remove the rear door module. (Refer to Body - "Rear Door Module")
7. 7
   Disconnect the actuator connectors.

   

   No	Terminal Information
   	left	Right Side
   1	-	-
   2	Lock/Unlock Switch	Motor 2
   3	COM	Motor 3
   4	-	-
   5	-	-
   6	Motor 3	COM
   7	Motor 2	Lock/Unlock Switch
   8	-	-

8. 8
   Check actuator operation by connecting power and ground according to the table. To prevent actuator damage, apply battery voltage only momentarily.

   

   

9. 9
   Remove the trunk lid trim. (Refer to Body - "Trunk Lid Trim")
10. 10
    Disconnect the actuator connector.

    

11. 11
    Check actuator operation by connecting power and ground according to the table. To prevent actuator damage, apply battery voltage only momentarily.

    

    

12. 12
    Check the trunk power supply of the variant, refer to the main body module.